Huawei NetEngine80E Configuration Manual - Reliability page 1170

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
Issue 02 (2014-09-30)
To configure the protection path in IP redirection mode, you need to deploy the directly
connected link between the devices that back up each other.
1. Run:
system-view
The system view is displayed.
2. Run:
remote-backup-service service-name
The remote backup service view is displayed.
3. Run:
protect redirect ip-nexthop ip-address interface interface-type interface-
number
The protection path is configured to work in IP redirection mode for public users. The
peer IP address and local outbound interface must be specified.
4. Run:
ip-pool pool-name
The primary address pool is bound to the RBS.
Configure the protection path in tunnel mode for public users.
1. Run:
system-view
The system view is displayed.
2. Run:
remote-backup-service service-name
The remote backup service view is displayed.
3. Run:
protect tnl-policy policy-name peer-ip ip-address [ interface interface-
type interface-number ]
The protection path is configured to be the label switched path (LSP), Multiprotocol
Label Switching (MPLS) Traffic Engineering (TE) tunnel, or Generic Routing
Encapsulation (GRE) tunnel for public users. The tunnel type is specified by the tunnel
policy and the outbound interface is optional.
4. Run:
ip-pool pool-name
The primary address pool is bound to the RBS.
Configure the protection path for VPN users.
1. Run:
system-view
The system view is displayed.
2. Run:
remote-backup-service service-name
The remote backup service view is displayed.
3. Run:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 Multi-node Backup Configuration
1153