Configuring User Information Backup In Shared Ip Address Pool Mode - Huawei NetEngine80E Configuration Manual - Reliability

Hide thumbs Also See for NetEngine80E:

Table of Contents

HUAWEI NetEngine80E/40E Router

Configuration Guide - Reliability

The system view is displayed.

remote-backup-profile profile-name

The remote backup profile view is displayed.

traffic backup { interval interval-value [ threshold threshold-value ] | threshold

threshold-value [ interval interval-value ] }

The interval for backing up traffic or the traffic threshold is set.

11.5.5 Configuring User Information Backup in Shared IP Address

The sharing address pool mode needs additional links but the networking is flexible.

If the exclusive IP address pool mode is adopted, a great number of address pools are needed.

This wastes addresses. The shared IP address pool mode addresses this problem. To adopt the

shared IP address pool mode, the following conditions must be met:

Perform the following steps on the devices that back up each other:

Issue 02 (2014-09-30)

Address pools cannot be bound to the RBP.

Both the active and standby devices need to advertise the address pool segment route and

be configured with route policy. In this manner, the address pool segment route advertised

by the active device has a higher priority; load balancing is not performed on the router of

the network side.

A protection tunnel, for example, an LSP, needs to be set up between the active and standby

devices. When the uplink of the user fails, the downstream traffic of the user is introduced

to the protection tunnel.

The address pool is bound to the RBS, that is, the ip-pool pool-name [ metric metric-

num ] or ipv6-pool pool-name [ metric metric-value ] command is used in the RBS view.

This ensures that traffic at the network side can be forwarded through the protection tunnel

before the host route is generated.

Only the primary address, not the secondary address pool, is bound to the RBS.

Configure the protection path in IP redirection mode for public users.

To configure the protection path in IP redirection mode, you need to deploy the directly

connected link between the devices that back up each other.

Huawei Proprietary and Confidential

11 Multi-node Backup Configuration

Netengine40e