Checking The Configurations - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
----End

11.6.4 Checking the Configurations

After successfully configuring multicast two-node hot backup, you can view multicast two-node
hot backup configurations and statistics.
Context
Run the following commands to check the previous configuration.
Procedure
l
l
----End
Example
After completing multicast two-node hot backup configurations, run the display remote-
backup-profile command. If the following information is displayed, the preceding
configurations are successful:
l
l
<HUAWEI> display remote-backup-profile profile1
-----------------------------------------------
Profile-Index
Profile-Name
Service
Remote-backup-service: service1
Backup-ID
track protocol
VRRP-ID
VRRP-Interface
Interface
State
Peer State
Backup mode
Slot-Number
Card-Number
Port-Number
Traffic threshold
Traffic interval
DHCP user IGMP copy
<HUAWEI> display multicast-rui statistic all
------------------Multicast RUI statistic-------------------
Main board:
Master send to slave: 0
Send fail: 0
Issue 02 (2014-09-30)
NOTE
After the undo dhcp-stb igmp-copy command is run, the system stops forwarding IGMP messages sent
by a DHCP STB, and the forwarded IGMP messages are not affected.
Run the display remote-backup-profile [ profile-name ] command to check RBP
information.
Run the display multicast-rui statistic all command to check statistics about multicast
two-node hot backup of access users.
The value of the Service field is bras multicast.
The value of the DHCP user IGMP copy field is enable or disable.
: 0x800
: profile1
: bras multicast
: 10
: VRRP
: 1
: Eth-Trunk1.2
:
: Master
: Slave
: hot
: --
: --
: --
: 50(MB)
: 10(minutes)
: enable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Eth-Trunk1.1
Slave receive: 0
Receive fail: 0
11 Multi-node Backup Configuration
1175