NEC UNIVERGE SV8100 Features & Specifications Manual page 544

Issue 5.0
Easy Edit reference
o
Blade Configuration, Virtual Loopbacks, Virtual Loopback -Extension Port.
o
4. Give the department group a pilot number (e.g. 5 - re-configuration of system numbering will be
required for this.)
Easy Edit references
o
Blade Configuration, Virtual Loopbacks, Virtual Loopback Department group
o
Blade Configuration, Virtual Loopbacks, Numbering Plan.
o
5. Allocate additional digits required e.g. 2
Easy Edit reference
o
Blade Configuration, Virtual Loopbacks, Virtual Loopback Basic Setup, S-Point DDI Digits.
o
6. Place virtual loopback trunk ports into a trunk group
Easy Edit reference
o
Blade Configuration, Virtual Loopbacks, Virtual Loopback Routing, Virtual Loopback Trunk Group
o
7. Configure DDI routing for trunk group and virtuals ddi's in this example 500 - 599
Easy Edit References
o
Cards, Virtual Loopback Setup, Virtual Loopback Routing, Virtual loopback DDI Table Area Setup
o
Blade Configuration, Virtual Loopbacks, Virtual Loopback Routing, Virtual Loopback DDI Table Area
o
Target,
Blade Configuration, Virtual Loopbacks, Virtual Loopback Routing, Virtual Loopback Trunk Type
o
Blade Configuration, Virtual Loopbacks, Virtual Loopback Routing, Virtual Loopback DDI Routing Table.
o
8. To configure, for example 500 to IRG 1 enter receive digits as 500 in a DDI table and enter target 2
with IRG 1.
It should now be possible to dial 500 internally and ring IRG 1.
The same scenario could be used for dialling across System Feature Networking.
1 - 534
UNIVERGE SV8100
Flexible Transfer/Virtual Loopback