NEC UNIVERGE SV8100 Features & Specifications Manual page 629

UNIVERGE SV8100
Program
Number
10-06-02
10-06-03
10-06-04
21-12-01
ISDN – PRI Installation
Program
Number
10-03-04
10-03-06
10-03-08
10-03-09
ISDN Compatibility
Program Name
ISDN BRI Setup – DID Mode
ISDN BRI Setup – SPID 1
ISDN BRI Setup – SPID 2
ISDN Calling Party Number
Setup for Trunks – Calling Party
Number Data
Program Name
ETU Setup (PRTA PKG Setup) –
Layer 3 Timer Type
ETU Setup (PRTA PKG Setup) –
Length of Cable
ETU Setup (PRTA PKG Setup) –
Dial Sending Mode
ETU Setup (PRTA PKG Setup) –
Dial Information Element
Description/Comments
Select the method the system
uses when assigning DID Mode to
the BRI Circuit.
Assign the SPID Number for
B-Channel 1.
Assign the SPID Number for
B-Channel 2.
Assign Calling Party Numbers for
each trunk (maximum 16 digits per
entry).
.
After the above programming
is complete a reset of the
CD-2BRIA is required.
Description/Comments
Setup and confirm the Basic
Configuration data for each
CD-PRTA This program selects
the Layer 3 timer type (1~5). Each
timer value of Layer 3 is set up for
each type in Program 81-06
(T-Bus).
Setup and confirm the Basic
Configuration data for each
CD-PRTA. Select the length of
cable to be used.
ISDN protocol definition. Select
either enblock or overlap sending.
ISDN protocol definition. If Overlap
Sending is selected in Program
10-03-08, select either Keypad
Facility (0) or Called Party Number
(1) for the dial information
element.
Issue 5.0
Assigned Data
0 = Route by Called
Party Number
1 = Route by
Redirecting Number
(default = 0)
Dial up to 20 digits
(default not assigned)
Dial up to 20 digits
(default not assigned)
(maximum 16 digits)
*
#
1-0, ,
Default:
(All trunks = No setting)
Assigned Data
1~5
(default = 1)
0 = Level 1
1 = Level 2
2 = Level 3
3 = Level 4
4 = Level 5
(default = 2)
0 = Enblock Sending
1 = Overlap Sending
(default = 0)
0 = Keypad Facility
1 = Called Party
Number
(default = 0)
1 - 619