NEC UNIVERGE SV8100 Features & Specifications Manual page 372

Issue 5.0
Operation
To set the destination number for each department group:
(Cannot be set from an analogue SLT.)
1. Press SPK to go off hook.
2. Dial 704.
3. Dial the department group number (01 to 64).
4. Dial the night mode number (1 to 8).
5. Dial the internal destination or off premise destination number (include any trunk access digits for
off premise).
6. Press HOLD to set the destination for other night modes.
7. Press SPK to hang up.
Note that at step 5 the destination number will be saved to the Abbreviated Dial bin number specified by
.
Program 24-05-01 for the chosen night mode.
If the same Abbreviated Dial bin is also used for other night modes then you do not need to set them separately.
.
For example at default bin number 1999 is used for all night modes so when a night mode destination number is
set for any night mode it will be used for all night modes.
To enable the call forward for incoming calls to a department group:
1. Press SPK to go off hook.
2. Dial department group call forward service code - 702.
3. Dial the department group number (01 to 64).
4. Press SPK to hang up.
5. Repeat steps 1 to 4 for further department groups.
- OR -
6. Press the department group call forward function key (851+58+group number). The key will flash
red when the call forward is set.
To cancel the call forward for incoming calls to a department group:
1. Press SPK to go off hook.
2. Dial department group call forward cancel service code - 703.
3. Dial the department number (01 to 64).
1 - 362
UNIVERGE SV8100
Department Call Forward