NEC UNIVERGE SV8100 Features & Specifications Manual page 417

UNIVERGE SV8100
Program
Number
22-02-01
22-04-01
22-07-01
22-08-01
Operation
To answer a call on your Direct Inward Line:
1. Lift the handset.
2. Press the flashing line key for DIL on the multiline terminal.
Direct Inward Line (DIL)
Program Name
Incoming Call Trunk Setup
Incoming Extension Ring Group
Assignment
DIL Assignment
DIL/IRG No Answer Destination
Description/Comments
Assign each DIL Service Type 4.
Make an entry for each Night
Service mode.
Assign the extensions that should
receive the overflow to the ring
group programmed in Program
22-08. Set the ringing in Program
22-06.
Set the destination extension
number for each DIL – for each
Night Service mode. The
destination can be an extension
port, virtual extension number, or
Department Group pilot number
(as assigned in Program
11-07-01).
For each DIL with delayed ringing,
enter the DIL No Answer Ring
Group. An unanswered DIL rings
this group after the DIL No Answer
Time. Make an entry for each
Night Service mode.
Issue 5.0
Assigned Data
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring
for incoming Ring
Group 1 calls. No
other extensions ring
for incoming Ring
Group 1 calls.
Extension Number
(maximum eight digits)
(default not assigned)
0 (No Setting)
001~100
(Incoming Ring Group)
102 (In-Skin/
External Voice Mail
or InMail)
(default = 1)
1 - 407