NEC UNIVERGE SV8100 Features & Specifications Manual page 631

UNIVERGE SV8100
Program
Number
21-01-03
21-12-01
DID Services for either ISDN – BRI or PRI
Program
Number
22-02-01
22-09-01
22-11-01
22-11-02
ISDN Compatibility
Program Name
System Options for Outgoing
Calls – Trunk Interdigit Time
(External)
ISDN Calling Party Number
Setup for Trunks – Calling Party
Number Data
Program Name
Incoming Call Trunk Setup
DID Basic Data Setup – Expected
Number of Digits
DID Translation Number
Conversion – Received Number
Translation Number Conversion
– Target Number
Description/Comments
The time the system waits for the
timer to expire before placing the
call in a talk state.
Assign Calling Party Numbers for
each trunk (maximum 16 digits per
entry).
. After the above programming
is complete a reset of the
CD-PRTA is required.
Description/Comments
Assign the incoming trunk type for
each trunk.
For each DID Translation Table
(1~20), enter the number of digits
the table expects to receive from
the CO (eight maximum). For
example, for a table used with
3-digit DID service, enter 3.
For additional DID Services refer
to Direct Inward Dialing (DID) on
page 1-385.
For each DID Translation Table
entry (1~2000), specify the digits
received by the system.
For each DID Translation Table
entry (1~2000), specify the
extension the system dials after
translation.
Issue 5.0
Assigned Data
0~64800 (seconds)
(default = 5)
(maximum 16 digits)
* #
1-0, ,
Default:
(All trunks = No setting)
Assigned Data
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
1~8
(default = 4)
(maximum eight digits)
(default not assigned)
(maximum 24 digits)
(default not assigned)
1 - 621