NEC UNIVERGE SV8100 Features & Specifications Manual page 425

UNIVERGE SV8100
Program
Number
20-06-01
20-09-01
20-13-23
20-14-01
20-14-02
20-14-03
20-14-04
Direct Inward System Access (DISA)
Program Name
Class of Service for Extensions
Class of Service Options
(Incoming Call Service) –
Second Call for DID/DISA/DIL/
E&M Override
Class of Service Options
(Supplementary Service) –
Display the Reason for Transfer
Class of Service Options for
DISA/E&M – First Digit
Absorption (Delete First Digit
Dialed)
Class of Service Options for
DISA/E&M – Trunk Group
Routing/ARS Access
Class of Service Options for
DISA/E&M – Trunk Group
Access
Class of Service Options for
DISA/E&M – Outgoing System
Speed Dialing
Description/Comments
Assign a Class of Service (1~15)
to an extension.
Turns Off (0) or On (1) the
extension ability to receive a
second call from a DID, DISA, DIL,
or tie line caller.
. With this option set to 1, the
destination extension must
be busy for a second DNIS
caller to ring through. If the
destination extension does
not have a trunk or CAP key
available for the second call
and a previous call is ringing
the extension but has not yet
been answered, the second
caller hears busy regardless
of this program setting.
Select whether an extension
should display the reason a call is
being transferred to their
extension (Call Forward Busy, Call
Forward No Answer, DND).
For tie lines, enable or disable the
ability to absorb (ignore) the first
incoming digit. Use this to make
the tie trunk compatible with
3- and 4-digit tie line service. This
option does not apply to DISA.
This option enables or disables a
DISA or tie trunk caller ability to
dial 9 for Trunk Group Routing or
Automatic Route Selection (ARS).
This option enables or disables a
DISA or tie trunk caller ability to
access trunk groups for outside
calls (Service Code 804).
This option enables or disables a
DISA or tie trunk caller ability to
use the System Speed Dialing.
Issue 5.0
Assigned Data
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
1 - 415