NEC UNIVERGE SV8100 Features & Specifications Manual page 319

UNIVERGE SV8100
Guide to Feature Programming
Program
Number
11-10-17
11-11-33
20-06-01
20-08-08
21-09-01
21-09-02
21-10-01
90-19-01
Operation
To set Dial Block:
1. At the multiline terminal, press Speaker
- OR -
Code Restriction, Dial Block
Program Name
Service Code Setup (for System
Administration) – Dial Block by
Supervisor
Service Code Setup (for Setup/
Entry Operation) – Dial Block
Class of Service for Extensions
Class of Service Options
(Outgoing Call Service) – Toll
Restriction Dial Block
Dial Block Setup – Toll
Restriction Class with Dial Block
Dial Block Setup – Supervisor
Password
Dial Block restriction Class per
Extension
Dial Block Release
Description/Comments
Assign a service code to be used
by the supervisor to set Dial Block
for another extension.
Assign a service code to be used
for Dial Block.
Assign a Class of Service (1~15)
to extensions.
Turn off or on an extension ability
to use Dial Block.
Assign a Code Restriction COS
(1~15) when the Dial Block feature
is used.
Assign a 4-digit password to be
used by the supervisor to enable
or disable Dial Block for other
extensions.
Assign the Code Restriction COS
(1~15) to be used by an extension
when the Dial Block feature is
enabled. If this data is "0", Code
Restriction COS follows Program
21-09-01.
Enter the extension number to be
released from the Dial Block
Restriction. This program can be
used when a password is forgotten
by the user.
Issue 5.0
Assigned Data
MLT
(default = 701)
MLT, SLT
(default = 700)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension ports =
Class 1
0 = Off
1 = On
(default = 0 for
COS 1~15)
1~15
(default = 15)
*
0~9, , #
(4-digit fixed)
(default not assigned)
0, 1~15
(0 = No Setting)
(default = 0)
[Release?]: Dial 1+
press Transfer
(Press Hold to cancel.)
1 - 309