NEC UNIVERGE SV8100 Features & Specifications Manual page 295

UNIVERGE SV8100
Certain trunks can be completely unrestricted, such as the company president's Private
Line. Users can place calls on Code Free Trunks anytime – to anywhere, without
inadvertently being Code restricted.
PBX Call Restriction
Code Restriction programming lets you enable/disable PBX Call Restriction and enter PBX
access codes. You only need to do this if your system is behind a PBX and you have trunks
programmed for behind PBX operation. Additional Default Entries For Common Permit
Code Table
Additional entries have been added to the default Common Permit Code Table. The default
setting is as follows:
Table 1: 911
Table 2: 1800
Table 3: 1888
Tie Line Code Restriction Enhanced
In Program
0, the system follows the setting in Program
Tie Line Calls
be followed. If this option is set to 1, the system follows the system Code restriction settings
defined in Program 21-05-01 through Program 21-05-13.
A user can temporarily override an extension's Code Restrictions.
The system allows or denies outgoing access to trunks depending on Code Restriction.
When using DISA or Tie Lines, additional programming is required for Code Restriction
(DISA, refer to Program 25-10; Tie Lines, refer to Program 34-04).
A user can temporarily block their extension Code Restriction access, preventing unwanted
calls from being placed on their telephone while they are away from their desk.
A phone and a trunk will have a Restriction Class. The higher class applies for outgoing
calls.
For example:
When trunk class is 01 and station class 02, Toll Restriction Class 02 is applied.
o
When trunk class is 15 and station class 03, Toll Restriction Class 15 is applied.
o
Default Setting
Disabled
Code Restriction
Table 4: 1822
Table 5: 1833
Table 6: 1844
34-01-05: E&M Tie Line Basic Setup – System Code Restriction, if
to determine whether or not the Code restriction setting in Program 34-08 is to
Table 7: 1855
Table 8: 1866
Table 9: 1877
21-05-13: Code Restriction Class – Restriction of
Issue 5.0
this option is set to
1 - 285