NEC UNIVERGE SV8100 Features & Specifications Manual page 410

Issue 5.0
Program
Number
25-07-13
25-07-14
Direct Call by Time Schedule
Program
Number
11-10-35
15-07-01
20-07-26
22-02-01
1 - 400
Program Name
System Timers for VRS/DISA –
VRS/DISA Busy Tone Interval
System Timers for VRS/DISA –
Delayed VRS Answer Time
Program Name
Service Code Setup (for
Administrator) – Dial-In Mode
Switching
Programmable Function Keys
Class of Service Options
(Administrator Level) – Dial-In
Mode Switch
Incoming Call Trunk Setup
Description/Comments
If a DISA caller dials a busy
extension (and Program 25-04-01
= 0), the system plays busy tone
for this time before disconnecting.
Assign the delay time from
switching from a normal incoming
status to DID mode. If this time is
set to 0, the call switches to DID
mode immediately.
Description/Comments
Assign the service code Dial-In
Mode Switching.
Assign a function key for
one-touch access to the Dial-In
Mode Switching setup code (Code
88).
Enable (1) or Disable (0) an
extension ability to manually
change Dial-In Modes.
For each Night Service Mode,
enter service type 8 when the
trunk should be a DID (DDI) Mode
Switching trunk.
UNIVERGE SV8100
Assigned Data
0~64800 (seconds)
(default = 5 seconds)
0~64800 (seconds)
(default = 10 seconds)
Assigned Data
MLT, SLT
(default not assigned)
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
* *
00 ~ 99
(Appearance Function
Code) (Service Code
852 by default)
0 = Off
1 = On
(default = 0 for
COS 1~15)
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
Direct Inward Dialing (DID)