NEC UNIVERGE SV8100 Features & Specifications Manual page 236

Issue 5.0
Guide to Feature Programming
Program
Number
11-10-32
11-10-33
11-10-34
13-02-01
13-04-01
13-04-03
13-04-04
1 - 226
Program Name
Service Code Setup (for System
Administrator) – Set Private Call
Refuse
Service Code Setup (for System
Administrator) – Entry Caller ID
Refuse
Service Code Setup (for System
Administrator) – Set Caller ID
Refuse
Group Speed Dialing Bins
Speed Dialing Number and Name
– Speed Dialing Data
Speed Dialing Number and Name
– Transfer Mode
Speed Dialing Number and Name
– Transfer Destination Number
Description/Comments
Enable/Disable the Private Call
Refuse (trunks) which are set in
Program 14-01-27.
Add/Delete the Caller ID to refuse.
. This operation must be
performed from a Keyset.
Enable/Disable the Caller ID
number (trunks) which are set in
Program 14-01-27.
Designate the starting bin number
the system uses for Group Speed
Dialing.
Enter the System and Group
Speed Dialing numbers and
names.
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
UNIVERGE SV8100
Assigned Data
MLT, SLT
(default not assigned)
MLT
(default not assigned)
MLT, SLT
(default not assigned)
01~64
(default not assigned)
*
#
1~9, 0, ,
Pause (Press line key
1)
Recall/Flash (Press
line key 2)
@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
0 = Not Used
1 = Internal Dial
2 = Incoming Ring
Group (IRG)
(default = 0)
If Transfer mode is
(Refer to 13-04-03):
1 = Internal Dial Mode
* #
1~9, 0, , , P, R, @
(Maximum 24
Characters)
2 = Incoming Ring
Group
0 ~ 100 (IRG Number)
P=Pause R=Recall
@= Additional Digits
when using ISDN
functionality
(default not assigned)
Caller ID – Flexible Ringing