NEC UNIVERGE SV8100 Features & Specifications Manual page 546

Issue 5.0
Guide to Feature Programming
Program
Number
11-10-26
20-06-01
20-07-11
21-01-18
Operation
To disconnect a busy trunk:
Multiline Terminal
1. Press line key for trunk.
- OR -
Dial trunk access code (805 + trunk number).
You hear busy tone. Trunk numbers are 001~200.
.
2. Dial the Service Code (724).
You hear confirmation beeps as the system disconnects the trunk.
.
You can now place a call on the free trunk.
.
3. Press the line key for the trunk disconnected in Step 2.
1 - 536
Program Name
Service Code Setup (for System
Administrator) – Forced Trunk
Disconnect
Class of Service for Extensions
Class of Service Options
(Administrator Level) – Forced
Trunk Disconnect (analog trunk
only)
System Options for Outgoing
Calls – Reset Dial After Failure of
Trunk Access
Description/Comments
Assign the Service Code.
Assign a Class of Service (COS)
to an extension. There are 15
Classes of Service that can be
assigned. Assign eight entries,
one for each Night Service Mode.
Turns Off (0) or On (1) an
extension to use Forced Trunk
Disconnect. This allows the
extension to disconnect an
Unsupervised Conference in
progress.
Enable (1) or Disable (0) the ability
to continue to dial codes or
extensions after receiving Trunk
Busy. This needs to be set to
Enabled (1) for this feature to
work.
UNIVERGE SV8100
Assigned Data
MLT, SLT
(default = 724)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extensions = Class
1
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Disable
1 = Enable
(default = 1)
Forced Trunk Disconnect