NEC UNIVERGE SV8100 Features & Specifications Manual page 888

Issue 5.0
Guide to Feature Programming
Program
Number
10-03-01
10-03-03
10-03-04
10-09-01
15-03-01
15-03-03
1 - 878
Program Name
ETU Setup (DLCA PKG Setup) –
Terminal Type (B1)
ETU Setup (LCA PKG Setup) –
Transmit Gain Level (S-Level)
ETU Setup (LCA PKG Setup) –
Receive Gain Level (R-Level)
DTMF and Dial Tone Circuit
Setup
Single Line Telephone Basic
Data Setup – SLT Signaling Type
Single Line Telephone Basic
Data Setup – Terminal Type
Description/Comments
Program all on-premise single line
telephones with circuit type 2. Set
the DIOPU trunk to type 1 when
trunks should be defined for off-
premise extension (OPX) use.
Use to setup and confirm the
Basic Configuration data for each
blade.
Assign transmit and receive levels
for single line telephones.
If the system has DTMF single line
extensions, allocate at least one
circuit for analog extension DTMF
reception (entry 0 or 1).
Use the following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one
DTMF receiver for every 10
devices that use them.
In heavy traffic sites, allocate
one DTMF receiver for every
five devices that use them.
Enter 0 if single line telephone is a
dial pulse. Enter 1 if single line
telephone is DTMF.
. In-Skin Voice Mail and InMail
set to 0.
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always
enter 1 (e.g., receive DTMF
tones).
UNIVERGE SV8100
Assigned Data
0 = Not set
1 = Multiline Terminal
2 = SLT Adapter
3 = Bluetooth Cordless
Handset
6 = PGD (Paging)
7 = PGD (Tone Ringer)
8 = PGD (Doorbox)
9 = PGD (ACI)
10 = DSS Console
11 = -- Not Used --
(default = 0)
1~63 (-15.5 +15.5dB)
[default = 32 (0dB)]
1~63 (-15.5 +15.5dB)
[default = 32 (0dB)]
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
0 = DP
1 = DTMF
(default = 1)
0 = Normal
1 = Special
(default = 0)
Single Line Telephones