NEC UNIVERGE SV8100 Features & Specifications Manual page 219

UNIVERGE SV8100
The system can queue incoming calls to the single line telephone if the system Caller ID sender
resources are busy. Refer to Program 20-19-05 in the UNIVERGE SV8100 Programming Manual.
If the single line telephone user lifts their handset while an incoming call is waiting in queue, they hear
silence (no dial tone) and cannot dial out. When the single line telephone user goes back on-hook, the
system immediately sends the queued call to the single line telephone without Caller ID.
Option Available for FSK or DTMF Type for Single Line Telephone
An option (Program 15-03-11) is available for the Caller ID which allows you to select either FSK or
DTMF as the Caller ID type to be received by a single line telephone.
Option Available for FSK or DTMF Type from Analog Trunk
An option (Program 14-02-16) is available for the Caller ID which allows you to select the type of Caller
ID signal from an analog trunk – FSK or DTMF.
Conditions
To have pre-answer Caller ID from the voice mail, the call must be an unscreened transfer.
Caller ID is provided by the CD-CP00. The PZ-BS10 blade, which plugs into the chassis,
can provide additional resources for Caller ID if needed.
Caller ID Name can display up to 12 characters.
Caller ID Number can display up to 11 characters.
A Caller ID Number with more than 12 digits follows Program 20-19-01 (first 10 or the last
10 digits).
Caller ID information can be stored in Speed Dialing or One-Touch bins.
Caller ID can be displayed for incoming calls and transferred calls.
ARS can block outgoing Caller ID information on a call-by-call basis. To do this, insert the
Caller ID block code (e.g., .141) in the ARS Dial Treatments.
Trunks with Privacy Release enabled display Caller ID until the call is answered. To view it
after the call has been picked up, press the line key, which sets the call to private mode. To
keep the call on Privacy Release, press the Help + Exit keys.
An extension user can display the Caller ID information for a call in Park if Automatic
Handsfree in Program 15-02-08 is set to 0 (Preselect).
An extension user can display the Caller ID information for multiple incoming calls without
answering the call by pressing the line key if Automatic Handsfree in Program 15-02-08 is
set to 0 (Pre-select).
Caller ID information outputs on the SMDR report.
The system can send Caller ID digits to the voice mail if allowed in Program 14-02-10.
Caller ID
Issue 5.0
1 - 209