NEC UNIVERGE SV8100 Features & Specifications Manual page 1033

UNIVERGE SV8100
Guide to Feature Programming
Program
Number
10-09-01
11-12-14
14-02-11
14-05-01
Trunk Groups
Program Name
DTMF and Dial Tone Circuit
Setup
Service Code Setup (for Service
Access) – Trunk Group Access
Analog Trunk Data Setup – Next
Trunk in Rotary if No Dial Tone
Trunk Group – Trunk Group
Number
Description/Comments
Allocate the circuits on the
CD-CP00 for either DTMF
receiving or dial tone detection.
If the service code for Trunk Group
Access (804 by default) is not
acceptable, change it as
necessary.
Use this option to Disable (0) or
Enabled (1) the system ability to
skip over a trunk if dial tone is not
detected. This pertains to calls
using Call Appearance (CAP)
Keys, Speed Dial, ARS, Last
Number Redial, or Save Number
Dialed. It does not pertain to line
keys or Direct Trunk Access calls.
Assign trunks to trunk groups.
Issue 5.0
Assigned Data
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
MLT, SLT
(default = 804)
0 = Disable
1 = Enable
(default = 0)
Trunk Group Number:
0~100 Priority Number:
1~200 (default = Trunk
Group 1, with priority in
ascending order.)
1 - 1023