NEC UNIVERGE SV8100 Features & Specifications Manual page 258

Issue 5.0
Guide to Feature Programming
Program
Number
10-03-XX
11-01-01
11-09-01
11-09-02
11-10-27
11-11-13
11-12-01
11-12-14
14-01-01
1 - 248
Program Name
ETU Setup
System Numbering
Trunk Access Code
Trunk Access Code – 2nd Trunk
Route Access Code
Service Code Setup (for System
Administrator) – Trunk Port
Disable for Outgoing Calls
Service Code Setup (for Setup/
Entry Operation) – Display
Language Selection for Multiline
Terminal
Service Code Setup (for Service
Access) – Bypass Call
Service Code Setup (for Service
Access) – Trunk Group Access
Basic Trunk Data Setup – Trunk
Name
Description/Comments
Use program 10-03-XX to setup
and confirm the basic
configuration data for each blade.
This program represents different
data depending on the blade
installed in the slot. Please refer
the SV8100 Programming Manual
for a more detailed description of
this program.
Use to set system numbering plan.
If required, change the single-digit
Trunk Access Code (normally 9). If
you change this code, you must
also review the settings in
Program 11-01-01 for the new
code selected.
Assign the Service Code set up in
Program 11-01-01 for Alternate
Trunk Route Access.
Define the service code which
should be used by an extension
user to block a trunk from being
used for outgoing calls.
Select the service code which can
be used at an extension to change
the displayed language on a
multiline terminal display
Define the service code for
Activating Call Forwarding/Do Not
Disturb Override. This code is
available only if you disable the
voice mail Single Digit dialing code
in Program 11-16-09.
Define the service code which
should be used by an extension
user to select outgoing Trunk
Group.
Set the names for trunks. The
trunk name displays on a multiline
terminal for incoming and outgoing
calls.
Central Office Calls, Placing
UNIVERGE SV8100
Assigned Data
The assigned data
varies depending on
the blade installed in
the slot. Please refer
to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
Refer to UNIVERGE
SV8100 Programming
Manual
Dial (up to four digits)
(default = 9)
Dial (up to four digits)
(default not assigned)
MLT, SLT
(default = 745)
MLT
(default = 778)
MLT, SLT
(default = 807)
MLT, SLT
(default = 804)
Up to 12 Characters
Line 001
Line 002
Line 003
:
Line 200