NEC UNIVERGE SV8100 Features & Specifications Manual page 298

Issue 5.0
Program
Number
21-01-15
21-01-16
21-01-17
21-04-01
21-05-01
21-05-02
21-05-04
21-05-05
1 - 288
Program Name
System Options for Outgoing
Calls – Outgoing Disable on
Incoming Line (Toll Restriction)
System Options for Outgoing
Calls – Supervise Dial Detection
Timer
System Options for Outgoing
Calls – Restriction Digit in
Outgoing Disable on Incoming
Line
Toll Restriction Class for
Extensions
Toll Restriction Class –
International Call Restriction
Table
Toll Restriction Class –
International Call Permit Code
Table
Toll Restriction Class –
Maximum Number of Digits Table
Assignment
Toll Restriction Class – Common
Permit Code Table
Description/Comments
Enable or disable the Incoming
Line feature system wide. When
enabled applies code restriction
when hook flash is sent on
inbound trunk followed by dialed
digits.
With the Outgoing Disable on
Incoming Line feature, if dial tone
is not detected after the extension
answers an incoming line, the
system determines the call is
unable to complete and releases
the DTMF receiver.
With the Outgoing Disable on
Incoming Line feature, determine
the number of digits (0~9) to be
dialed before the call should be
disconnected.
Use to assign a Toll Restriction
class to an extension for modes
1-8.
For the Toll Restriction Class you
select, assigned (1) or unassigned
(0) the International Call Restrict
Table (Program 21-06-01).
For the Toll Restriction Class you
select, assign (1) or unassign (0)
the International Call Permit Table
(Program 21-06-02).
Select the table (defined in
Program 21-06-03) to be used to
determine the maximum number
of digits allowed for outgoing calls.
It chooses whether the table set
up by Program 21-06-04 is
referred to, or not referred to.
UNIVERGE SV8100
Assigned Data
0 = Disable
1 = Enable
(default = 0)
0~64800 (seconds)
(default = 20 seconds)
Digits 0~9
(default = 4)
Day/Night Mode
1~9 (9 = Power Failure
Mode)
1~15
(default = 2)
0 = Unassigned (No)
1 = Assigned (Yes)
default:
1, 6~15 = 0
2~5 = 1
0 = Unassigned
1 = Assigned
default:
1, 3~15 = 0
2 = 1
1~4 =Table
0 =Disable (None)
Default:
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
0 = Unassigned
1 = Assigned
Default:
1, 8~15 = 0
2~7 = 1
Code Restriction