NEC UNIVERGE SV8100 Features & Specifications Manual page 828

Issue 5.0
Program
Number
44-02-03
44-02-04
44-03-01
44-03-02
44-03-03
1 - 818
Program Name
Dial Analysis Table for F-Route
Access – Additional Data
Dial Analysis Table for F-Route
Access – Dial Tone Simulation
Dial Analysis Extension Table –
Dial
Dial Analysis Extension Table –
F-Route Select Table Number
(1~250)
Dial Analysis Extension Table –
F-Route Select Table Number
(251)
Description/Comments
If a Service Type is set to F-Route
in Program 44-02-02, set which
F-Route table to be used.
Determine if the Dial Tone
Simulation is on (1) or off (0) for
the Pre-Transaction Table for
selecting F-Route. If enabled, this
option sends dial tone to the
calling party once the routing is
determined. This may be required
if the central office at the
destination does not send dial
tone.
Set the Dial digits (24 digits max:
*
#
1~9, 0 , @) to be used for the
Dial Extension Analysis Table.
When Program 44-02-02 is set to
type 3, this program sets the dial
extension analysis table. These
tables are used when the analyzed
digits must be more than eight
digits. To enter a wild card/don't
care digit, press Line Key 1 to
enter an @ symbol.
When dialed digits match the
setting in Program 44-03-01,
select the R-Route table number
(0~500) to be used for the Dial
Extension Analysis Table.
If the received digits are not
identified in tables 1~250, the
F-Route selection table number
(0~500) defined in table 251 is
used.
UNIVERGE SV8100
Assigned Data
1=Delete Digit = 0~255
(255 : Delete All Digits)
2=0~500 (0 = No
Setting)
3=Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
0 = Off
1 = On
(default = 0)
Up to 24 digits
*
Digits = 1~9, 0, , #, @
(Press Line Key 1 for
wild character @)
(default not assigned)
0~500
(F-Route Table
Number)
With Program 44-01
set to 0, Program
44-05 is checked.
With Program 44-01
set to 1, Program
44-04 is checked.
(default = 0)
0~500
(F-Route Table
Number)
With Program 44-01
set to 0, Program
44-05 is checked.
With Program 44-01
set to 1, Program
44-04 is checked.
(default = 0)
Q-Sig