NEC UNIVERGE SV8100 Features & Specifications Manual page 758

Issue 5.0
Guide to Feature Programming
Program
Number
10-03-01
10-09-01
15-03-01
15-03-03
15-03-05
15-03-06
15-03-07
1 - 748
Program Name
ETU Setup
DTMF and Dial Tone Circuit
Setup
Single Line Telephone Basic
Data Setup – SLT Signaling Type
Single Line Telephone Basic Data
Setup – Terminal Type
Single Line Telephone Basic
Data Setup – Trunk Polarity
Reverse
Single Line Telephone Basic
Data Setup – Extension Polarity
Reverse
Single Line Telephone Basic
Data Setup – Enabled On-Hook
When Holding (SLT)
Description/Comments
Use program 10-03-XX to setup
and confirm the basic
configuration data for each blade.
This program represents different
data depending on the blade
installed in the slot. Please refer
the SV8100 Programming Manual
for a more detailed description of
this program.
Allocate the circuits on the
CD-CP00 ETUs for either DTMF
receiving or dial tone detection.
Program 14-01-13 Basic Trunk
Data Setup – Loop Supervision
Enable (1) loop supervision for
each trunk that should be able to
use Call Forwarding – Centrex.
For each UNIVERGE SV8100
voice mail extension, this option
must be set to 0.
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always
enter 1 (e.g., receive DTMF
tones).
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
Used to enable or disable Enabled
On-Hook When Holding for SLT.
(OPX) Off-Premise Extension
UNIVERGE SV8100
Assigned Data
The assigned data
varies depending on
the blade installed in
the slot. Please refer
to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
0 = DP
1 = DTMF
(default = 1)
0 = Normal
1 = Special
(default = 0)
0 = Off
1 = On
(default = 0)
0 = Disable (Off)
1 = Enable (On)
(default = 0)
0 = No
1 = Yes
(default = 1)