After Replacing The Fixing Web; Fixing Jam Sensor; Removing The Delivery Jam Sensor; Claw Jam Sensor - Canon iR6570 series Service Manual

Chapter 9
[A]
Also, check to make sure that the fixing web is wound in the following
direction and orientation:
Take-up roller
2) When you have fitted the fixing web, move the plunger [1] of the
solenoid in the direction of the arrow until the fixing web is free of
slack.

9.5.11.3 After Replacing the Fixing Web

- If you have replaced the fixing web, be sure to reset the counter reading
to '0' using the following service mode items:
COPIER>COUNTER>MISC>FIX-WEB
COPIER>COUNTER>DRBL-1>FIX-WEB
9-40
F-9-116
Feed roller
F-9-117
[1]
F-9-118
0009-4956

9.5.12 Fixing Jam Sensor

9.5.12.1 Removing the Delivery Jam Sensor

1) Remove the fixing feeding unit from the machine.
2) Remove the outside delivery roller.
3) Remove the 2 screws [1], and pull out the sensor support plate toward
the outside.
4) Disconnect the connector [1], and detach the delivery jam sensor [2]
from the sensor support plate.

9.5.13 Claw Jam Sensor

9.5.13.1 Removing the Claw Jam Sensor

1) Remove the inside paper roller.
2) Remove the screw [1], and remove the protrusion [2]; then, pull out
the sensor support plate [3] toward the outside.
[1]
3) Disconnect the connector [1], and detach the claw jam sensor [2] from
the sensor support plate.
0009-4849
[1]
[2]
F-9-119
[2] [1]
F-9-120
0009-4877
[3] [2]
F-9-121