MLD
MLD S
C
AND
NOOPING
OMMANDS
6
-
IPV
MLD ROBUSTNESS
VARIABLE
ipv6 mld robustness-variable
Overview
Use this command to change the robustness variable value on an interface.
Use the no variant of this command to return to the default on an interface.
Syntax
ipv6 mld robustness-variable <value>
no ipv6 mld robustness-variable
Default
The default robustness variable value is 2.
Mode
Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Usage
This command applies to interfaces configured for MLD Layer-3 multicast
protocols.
awplus#
Example
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
C613-50077-01 REV A
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
ipv6 enable
ipv6 mld robustness-variable 3
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
1358