Panasonic KX-NS300 Pc Programming Manual page 70

5.3 System Control—System Reset
5.3 System Control—System Reset
When programming changes or other changes to PBX settings require a system reset, this command allows
a reset to be performed remotely from Web Maintenance Console.
When the system is reset, any settings not saved to the System Memory are lost. A backup should be
performed before the reset to ensure no data is lost. However, a backup should not be performed if settings
or data have recently been imported into the system, because performing a backup would overwrite the
imported data with the current PBX settings.
This screen can be accessed only in On-line mode.
[Manual System Reset]
1.
Select the System Reset tab.
2.
Confirm the contents of the displayed warning message.
3.
Click Backup or Skip according to the system's status:
•
Backup: Click to backup system settings. The system will be reset after the backup has been
performed.
•
Skip: The system is reset without performing a backup.
If you are logged in to the PBX that is reset using this command, it is necessary to re-log in to Web
Maintenance Console to continue programming.
[System Reset by Timed Schedule]
1.
Select the Timed Reset tab.
2.
Select the Reset Mode (None, One Time, One Time (KX-NT only), Daily).
3.
Set the Reset Time (00:00-23:59).
4.
Click Apply or OK to set the system reset.
The PBX will have its system reset at the specified mode and reset time, according to the above settings.
70 PC Programming Manual