Panasonic KX-NS300 Pc Programming Manual page 51

A •
Perform the following steps:
1.
On the 11.5.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group—
Group Settings screen, enter the floating extension number you chose for the ICD group in
the Floating Extension Number cell.
2.
Click Apply.
3.
On the 11.5.1.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group
—Group Settings—Member List screen, select the ICD group you created from the ICD
Group No. drop-down list.
4.
Enter the extension numbers of member extensions in the Extension Number column.
5.
Click Apply.
6.
On the DIL tab of the 18.2 PBX Configuration—[10-2] CO & Incoming Call—DIL Table &
Port Settings screen, enter the floating extension number of the ICD group as the DIL
Destination—Day, Lunch, Break, Night of each time mode.
7.
Modify other settings as required from the Group—Incoming Call Distribution Group
submenu.
Q How do I set the queuing operation for an Incoming Call Distribution group?
A •
Perform the following steps:
1.
On the 11.5.2 PBX Configuration—[3-5-2] Group—Incoming Call Distribution Group—
Queuing Time Table screen, set the actions as required for each queuing table.
2.
On the 11.5.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group—
Group Settings screen, from the Queuing Time Table tab, select the number of the
Queuing Time Table to use in each time mode.
Q How do I add an extension as a member of an Incoming Call Distribution (ICD) group?
A •
Perform the following steps:
1.
On the 11.5.1.1 PBX Configuration—[3-5-1] Group—Incoming Call Distribution Group
—Group Settings—Member List screen, from the ICD Group No. drop-down list, select
the group you want to modify.
The ICD group must have an extension number set.
2.
Enter the extension number of the extension you want to add in a blank cell of the
Extension Number column.
3.
Set Delayed Ring as necessary.
4.
Click Apply.
Note that it is necessary to set the extension number of the ICD group in advance.
Q I have set FWD through system programming, but calls are still not being forwarded.
A •
Perform the following steps:
1.
Check that the Forward / DND settings of the target extension on the 12.1.2 PBX
Configuration—[4-1-2] Extension—Wired Extension—FWD/DND or 12.2.2 PBX
Configuration—[4-2-2] Extension—Portable Station—FWD/DND screen are set to one of
the forwarding settings.
2.
Create a FWD button on the target extension if one does not already exist.
3.
Press the FWD button so that it changes to FWD status.
2.3 Frequently Asked Questions (FAQ)
PC Programming Manual 51