Panasonic KX-NS300 Pc Programming Manual page 225

9.13 PBX Configuration—[1-1] Configuration—Slot
—Card Property—V-IPEXT
The properties of the V-IPEXT card can be specified.
Name
Signalling
(MGCP) UDP
Port No. (IP-PT)
Keep Alive Time-
Out
First Resending
Time (PTAP)
Resending Time
Out (PTAP)
9.13 PBX Configuration—[1-1] Configuration—Slot—Card Property—V-IPEXT
Description
Indicates the UDP port used to transmit
and receive MGCP (Media Gateway
Control Protocol) data on the IP-PT
side (reference only).
Specifies the length of time that the
PBX will continue to consider an IP-PT
to be active even if it receives no
transmissions from that IP-PT. The
PBX constantly confirms the status of
IP-PTs. If no communications are
received from an IP-PT for the duration
specified here, the PBX considers the
IP-PT to be unreachable, and sets the
port status to Fault.
During operation, set between 10 s and
60 s. Settings over 60 s, and Disable,
are used for debugging purposes, and
IP-PTs cannot be guaranteed to
function normally in these
circumstances. Do not use debugging
settings unless instructed to do so.
To change the value displayed here,
click Common Settings and set the
desired value.
Specifies the length of time that the
PBX waits before starting to resend
PTAP (Panasonic Telephony
Administration Protocol) data.
To change the value displayed here,
click Common Settings and set the
desired value.
Specifies the length of time after which
the PBX terminates resending PTAP
(Panasonic Telephony Administration
Protocol) data.
To change the value displayed here,
click Common Settings and set the
desired value.
Value Range
Feature Manual
2427
References
5.2.1 IP Proprietary
Telephone (IP-PT)
Feature Manual
Disable, 10–120
s
References
5.2.1 IP Proprietary
Telephone (IP-PT)
500 × n (n=1– Feature Manual
16) ms
References
5.2.1 IP Proprietary
Telephone (IP-PT)
150–240 s Feature Manual
References
5.2.1 IP Proprietary
Telephone (IP-PT)
PC Programming Manual
Links
225