Panasonic KX-NS300 Pc Programming Manual page 289

9.29 PBX Configuration—[1-1] Configuration—Slot—Card Property—E1 type Line Signal Setting
9.29 PBX Configuration—[1-1] Configuration—Slot
—Card Property—E1 type Line Signal Setting
Name
DR2 Setting Type
Inter-digit Timer
Bit Position for
Dial Pulse
Bit Position for
Clear Back
Forced Release
Forced Release
Pattern
Meter Pulse
Detection—Mode
Meter Pulse
Detection—Bit
Position
Meter Pulse
Detection—Length
DSP Gain
Adjustment—
DTMF Transmit
DSP Gain
Adjustment—
DTMF Receive
Description
Selects the control type of the DR2
(Digital System R2) signal.
Specifies the pseudo-answer time. This
setting is available only when Option 1
or Option 3 is selected in DR2 Setting
Type on this screen.
Selects the position of the pulse dial
control bit in a DR2 signal.
Selects the position of the clear-back
signal control bit in a DR2 signal.
Enables the PBX to send a forced
release signal.
Selects the bit pattern for a forced
release signal.
Specifies the mode for call charge meter
pulses.
Specifies the bit position of a call charge
meter pulse.
Specifies the length that a call charge
meter pulse must be for the PBX to
recognise it as a call charge meter
pulse.
Specifies the output power of the DTMF
signal sent from the DSP (Digital Signal
Processor).
Specifies the strength range within which
a DTMF signal must be for the DSP to
recognise it as a DTMF signal.
Value Range
Normal, Option 1,
Option 3
3-15
A-bit, B-bit
A-bit, B-bit, A&B-bit
Disable, Enable
A=0/B=0, A=0/B=1,
A=1/B=0, A=1/B=1
No Detection: Meter
pulses are not sent
or received.
Outgoing call only:
Sends a call charge
meter pulse for
outgoing trunk calls.
Both calls: Sends
and receives call
charge meter pulses.
A-bit, B-bit, C-bit, D-
bit
8 × n (n=1–80) ms
-12 dB–3 dB
-42 - 0 dB – -11- 0
dB
PC Programming Manual
Links
Feature
Manual
References
2.29.1 E1 Line
Service
Feature
Manual
References
2.29.1 E1 Line
Service
Feature
Manual
References
2.29.1 E1 Line
Service
289