Panasonic KX-NS300 Pc Programming Manual page 27

CPU
RAM
Hard Disk
Copyright for MD5
This software uses the Source Code of RSA Data Security, Inc. described in the RFC1321 (MD5 Message-
Digest Algorithm).
Copyright (C) 1991-2, RSA Data Security, Inc. Created 1991. All rights reserved.
Licence to copy and use this software is granted provided that it is identified as the "RSA Data Security, Inc.
MD5 Message-Digest Algorithm" in all material mentioning or referencing this software or this function.
Licence is also granted to make and use derivative works provided that such works are identified as
"derived from the RSA Data Security, Inc. MD5 Message-Digest Algorithm" in all material mentioning or
referencing the derived work.
RSA Data Security, Inc. makes no representations concerning either the merchantability of this software or
the suitability of this software for any particular purpose. It is provided "as is" without express or implied
warranty of any kind.
These notices must be retained in any copies of any part of this documentation and/or software.
PC Connection (On-line Mode)
To connect to Web Maintenance Console in On-line mode, both the PC and the PBX must be connected.
The connection can be made through a local area network (LAN), a virtual private network (VPN), or over
the Internet. A PC can also be connected directly to the maintenance port of the PBX.
Connecting to Web Maintenance Console (On-line Mode)
Below is the procedure for connecting to Web Maintenance Console to programme in On-line mode:
1.
Connect the PC to the PBX:
•
Connect the PBX to a network with the LAN port and access the PBX from a PC in your LAN or VPN.
•
Connect the PBX to a network with the LAN port and access the PBX from a PC using an Internet
connection.
2.
Access Web Maintenance Console:
LAN or VPN connection:
Launch your Web browser and input the IP address of the PBX followed by the Web Maintenance
Console port number into the address bar. The input method will differ according to the PC's connection
to the PBX.
The default IP address for the LAN port of the PBX is 192.168.0.101, and the default Web Maintenance
Console port number is 80. Accordingly, the address to enter to connect to the PBX for the first time will
be as follows (enter the address exactly as shown):
http://192.168.0.101
MNT Port connection:
Launch your Web browser and in the address bar, enter one of the following addresses exactly as
shown:
– 223.0.0.1
or
3.2 GHz Intel Core™ 2 Duo processor or comparable CPU
®
2048 MB
10 GB available space
1.2.1 Starting Web Maintenance Console
Recommended Specification
PC Programming Manual 27