Panasonic KX-NS300 Pc Programming Manual page 269

Name
ISDN CO / QSIG
Master / QSIG Slave
—T316
ISDN CO / QSIG
Master / QSIG Slave
—T318
ISDN CO / QSIG
Master / QSIG Slave
—T319
ISDN CO / QSIG
Master / QSIG Slave
—T322
ISDN CO / QSIG
Master / QSIG Slave
—T3D3
ISDN CO / QSIG
Master / QSIG Slave
—T3D9
ISDN Extension—
T200
ISDN Extension—
T201
ISDN Extension—
T203
ISDN Extension—
T301
ISDN Extension—
T302
ISDN Extension—
T303
ISDN Extension—
T304
ISDN Extension—
T305
ISDN Extension—
T306
9.25 PBX Configuration—[1-1] Configuration—Slot—Card Property - BRI type/PRI type
Description
Specifies the maximum time that the PBX
waits for a reply after sending the Restart
message.
Specifies the maximum time that the PBX
waits for a reply after sending the Resume
message.
Specifies the maximum time that the PBX
waits for a reply after sending the Suspend
message.
Specifies the maximum time that the PBX
waits for a reply after sending the Status
enquiry message.
Specifies the length of time that the PBX tries
to establish L2 in "Permanent" mode.
Specifies the length of time that the PBX tries
to disconnect L2 in "Call by Call" mode.
Specifies the maximum time that the PBX
waits for a reply after sending the L2
command to ISDN.
Specifies the maximum time that the PBX
waits for a reply after resending the TEI check
request to ISDN.
Specifies the length of time to detect no
communication status of L2.
Specifies the maximum time that the PBX
waits for a reply after making a call to ISDN.
Specifies the maximum time allowed between
each digit on an incoming call. Applies to
overlap receiving.
Specifies the maximum time that the PBX
waits for a reply after sending the SETUP (call
setting) message to ISDN.
Specifies the maximum time allowed between
each digit on an outgoing call. Applies to
overlap sending.
Specifies the maximum time that the PBX
waits for a reply after sending the DISC
(disconnection) message to ISDN.
Specifies the maximum time that the PBX
waits for a reply after sending the DISC
(disconnection) message to ISDN. This setting
is used when inband tones are supplied.
Value Range
0–3000 × 100
ms
0–600 × 100
ms
0–600 × 100
ms
0–600 × 100
ms
0–3000 × 100
ms
0–3000 × 100
ms
0–600 × 100
ms
0–600 × 100
ms
0–600 × 100
ms
0–18000 × 100
ms
0–600 × 100
ms
0–600 × 100
ms
0–3000 × 100
ms
0–3000 × 100
ms
0–3000 × 100
ms
PC Programming Manual
Links
269