Panasonic KX-NS300 Pc Programming Manual page 214

9.10 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-SIPGW
Name
DTMF
Payload Type
RTP/RTCP
The Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
Name
Connection
RTP QoS
Ability
RTP QoS-ToS
Priority
RTP QoS-ToS
Type
RTP QoS-
DSCP
RTP QoS-HEX
RTCP Packet
Sending Ability
RTCP Packet
Interval
Keep Alive
Timer
T.38
The Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
214 PC Programming Manual
Description
Specifies the method to transport DTMF
tones.
Specifies the payload type of RFC2833 for
DTMF tones.
Note
Manual programming is required if
DTMF is set to Outband (RFC2833).
Description
Indicates the port status. To change the
status of the port, click the desired cell in the
column, and then select INS or OUS for the
port.
This option is only available in On-line mode.
Specifies the type of value to be stored in
the ToS field in the IP header.
Specifies the priority level in the ToS field.
Specifies the ToS type in the ToS field.
Specifies the value in the ToS field by a
DSCP for DiffServ.
Specifies the value in the ToS field by a
hexadecimal number.
Specifies whether to enable each port to
send RTCP packets.
Specifies the interval time until the next
RTCP packet is sent.
Specifies the length of time to send Keep
Alive packets for the connection. Specifying
"0 s" will disable the sending of Keep Alive
packets.
Value Range
Inband, Outband (RFC2833),
Outband (SIP INFO)
96–127
Value Range
INS: The port is in service.
OUS: The port is out of
service.
Fault: The port is not
communicating with the
network.
ToS, DSCP, HEX
0–7
Normal, Monetary Cost,
Reliability, Throughput,
Delay
0–63
00–FF
Disable, Enable
5–60 s
0 s, 10 s, 20 s, 30 s, 40 s,
50 s, 60 s
Links
Links