Panasonic KX-NS300 Pc Programming Manual page 100

7.1 Utility—Diagnosis
7.1 Utility—Diagnosis
7.1.1 Utility—Diagnosis—Card Diagnosis
Performs diagnostic tests on cards installed in the PBX, to identify the source of problems.
If any of the tests listed here returns the result "NG" ("No Good"), contact the seller where you purchased
this PBX.
When testing is complete, any cards that were set to OUS status must be returned to INS status if they are
to be used again.
This screen can be accessed only in On-line mode.
Card Test
Tests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary
according to the type of card being tested.
The tests that are performed on each card are listed below.
Test Type
Local loop back diagnosis
DTMF Receive test port
PT loop back diagnosis
To perform a card test
1. Click on the Status cell of the card to be tested, and set it to "OUS".
2. Click on the cell showing the card type.
A new window will be displayed.
3. Select the Card Test option, and then click Execute.
The error report will be displayed. When all tests are completed, the words "Test End!" will be shown on
the last line of the output.
4. Select an option:
•
Click Capture if you want to save the displayed information.
1.
Specify a save destination and file name.
2.
Click Save.
•
Click Cancel to return to the Diagnosis screen.
Note
To run consecutive card tests on the BRI2/BRI4 card, you must change the card's status to INS, then
OUS again after running each test.
7.1.2 Utility—Diagnosis—Ping
Performs a connection test on network devices. This function sends echo requests to a particular IP address
across an IP network, and displays the result of responses and round-trip time.
This screen can be accessed only in On-line mode.
To perform a Ping test
100 PC Programming Manual
DLC2, DLC8, DLC16, LCOT6 (Pre-installed/Option), BRI2, BRI4,
PRI23, PRI30/E1
DHLC4, MCSCL8, MCSLC16 (Pre-installed/Option)
DLC2, DLC8, DLC16, DHLC4
Available Cards