Panasonic KX-NS300 Pc Programming Manual page 571

Name
All Calls If this parameter is set to "Yes", the
Transfer to extension is considered to be a
Mailbox Logical Extension and therefore
calls directed to the extension via
Automated Attendant service are
automatically forwarded to the
extension mailbox. The extension
does not ring when a call is
received.
Call Specifies the method for the Call
Transfer Transfer Sequence used by the
Sequence mailbox. Allows each mailbox to be
(Selection) assigned its own Call Transfer
Sequence (Personal Transfer
Sequence).
Note
This sequence has higher
priority than the alternate
extension transfer sequence
specified in 24.4 UM
Configuration—[5-4] System
Parameters—Parameters—
PBX Parameters—PBX
Environment—Alternate
Extension Transfer Sequence
(Up to 16 digits / [0-9 * # D R F
T X , ;]).
Call Specifies the Call Transfer
Transfer Sequence used by the mailbox.
Sequence Only specified if Call Transfer
(Other) Sequence (Selection) is set to
"Other".
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
Description Value Range
No, Yes
System, Other
Note
When "System" is
selected, the Unified
Messaging system
uses the extension
transfer sequence pre-
programmed in
24.4 UM
Configuration—[5-4]
System Parameters
—Parameters—PBX
Parameters—PBX
Environment—
Extension Transfer
Sequence (Up to 16
digits / [0-9 * # D R F
T X , ;]).
Enter a maximum of 16
characters consisting of 0–
9, , # and special codes:
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone
Detection
T: Dial Tone Detection
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
X: Extension Dialling
0–9, , #: Dial Code
Links
Feature Manual
References
3.2.1.3 Automated
Attendant (AA)
PC Programming
Manual
References
24.4 UM
Configuration—[5-4]
System Parameters—
Parameters—PBX
Parameters—PBX
Environment—
Extension Transfer
Sequence (Up to 16
digits / [0-9 * # D R F
T X , ;])
Feature Manual
References
3.2.2.7 Call Transfer
Status
Feature Manual
References
3.2.2.7 Call Transfer
Status
PC Programming Manual 571