Panasonic KX-NS300 Pc Programming Manual page 575

Name
Telephone Assigns a telephone number to Device 1, 2, or
Device— 3. The subscriber can also specify the number
Device No. 1, to be dialled by entering it from his or her
2, 3—Dial telephone, allowing the subscriber to set this
Number [0-9 * feature on a case by case basis.
# T X , ;]
Note
When the Unified Messaging system calls a
trunk via the PRI card, be sure to add "#"
after the telephone number (1112223333 in
the example here):
9P1112223333#PP123PP456PPX# (P: Dial
Pause)
"X" is either the Caller ID information that
was received when the message was
recorded or the value of System Callback
No. if no Caller ID information was received.
Telephone Specifies the number of times the Unified
Device— Messaging system will try to send notification if
Device No. 1, the device is busy or if there is no answer.
2, 3—No. of
Retries
Telephone Specifies the time (in minutes) the Unified
Device— Messaging system waits before retrying
Device No. 1, message notification when the called device is
2, 3—Busy busy.
Delay Time
(min)
Telephone Specifies the time (in minutes) the Unified
Device— Messaging system waits before retrying
Device No. 1, message notification when the called device
2, 3—No does not answer.
Answer Delay
Time (min)
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting
Description Value Range
Max. 32 digits Feature
consisting of 0–9,
Manual
, # and special
References
codes:
3.2.1.30
, : Dial Pause
Message
(default 1 s)
Waiting
; : Dial Pause
Notification—
(default 3 s)
Telephone
T: Dial Tone
Device
Detection
X: Callback
Number Entry
Code
0–9, , #: Dial
Code
0–9 times Feature
Manual
References
3.2.1.30
Message
Waiting
Notification—
Telephone
Device
0–120 min Feature
Manual
References
3.2.1.30
Message
Waiting
Notification—
Telephone
Device
1–120 min Feature
Manual
References
3.2.1.30
Message
Waiting
Notification—
Telephone
Device
PC Programming Manual
Links
575