Panasonic KX-NS300 Pc Programming Manual page 184

9.2.4 PBX Configuration—[1-1] Configuration—Slot—System Property—NSVM
Name Description
Status Indicates the card
status (reference
only).
9.2.4 PBX Configuration—[1-1] Configuration—Slot—System
Property—NSVM
Settings related to audio quality and sound detection for the PBX site can be specified.
Name
Echo Cancellation
Ability
DSP Digital Gain
(Down)
DSP Digital Gain (Up)
EC Gain
NLP Setting
FAX Detection Ability
CNG Signal Effective
Detection Width 1
(ON)
CNG Signal Effective
Detection Width 2
(OFF)
CNG Signal Fixation
Detection Counter
CNG Signal Fixation
Detection Pattern
Maximum Silence
Time
Maximum Continuous
Tone Time
Unique Cyclic Tone
Detection
Maximum Cyclic Tone
Time
184 PC Programming Manual
Value Range
INS: The card is in service.
OUS: The card is out of service.
Fault: The card is not
communicating with the network.
Pre-Install: A card has been added
to the slot.
Description
Specifies the echo canceller ability time.
Specifies the DSP Digital Gain for the down voice
path.
Specifies the DSP Digital Gain for the up voice path.
Specifies the Echo Canceller Gain.
Specifies the NLP (Non-Linear Processor) setting to
control echo sound quality.
Enables the use of the FAX Detection Ability feature.
Since fax signals using a codec other than G.711
cannot be received accurately at the destination, this
feature automatically switches the codec to G.711 to
enable end-to-end fax signal relay over the network.
Specifies the length of time that the PBX detects the
CNG signal.
Specifies the length of time that the PBX waits until
another CNG signal is detected.
Specifies the number of times the CNG signal must
be detected before the PBX proceeds the fax
operation.
Specifies the CNG signal pattern to be detected
before the PBX proceeds the fax operation.
Specifies the length of time of silence that the PBX
will detect as the end of a call.
Specifies the length of time of a continuous tone that
the PBX will detect as the end of a call.
Specifies whether the system will detect the end of a
call when there is a unique cyclic tone.
Specifies the length of time of a continuing cyclic
tone that the PBX will detect as the end of a call.
Links
PC Programming Manual
References
9.1 PBX Configuration—[1-1]
Configuration—Slot
Value Range
OFF, 64 ms,
128 ms
-14–6 dB
-14–6 dB
-14–6 dB
Disable, Weak,
Normal, Strong
Disable,
Enable
20–5000 ms
20–5000 ms
1–3
OFF, ON
1000–60000
(ms)
1000–60000
(ms)
Disable,
Enable
1000–60000
(ms)
Links