Panasonic KX-NS300 Pc Programming Manual page 244

9.18 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-IPCS
9.18 PBX Configuration—[1-1] Configuration—Slot
—Port Property—V-IPCS
Various settings can be programmed for each virtual IP-CS port.
IP-CS Registration and De-registration
An IP-CS must be registered to the PBX by programming the PBX and IP-CS before it can be used.
Programming instructions for the PBX are given below.
It is possible to de-register the IP-CS later.
IP-CS Registration, De-registration, and Forced De-registration can be performed only in On-line mode.
Name
Preparation Open 27.1 Network Service—[1] IP Address/Ports—Basic Settings,
and confirm that the IP addresses of the mother board and DSP card,
subnet mask address, and default gateway address are set.
Registration Follow the steps below to register the IP-CS.
1.
2.
3.
4.
De- Follow the steps below to de-register the IP-CS.
registration
1.
2.
3.
4.
244 PC Programming Manual
Connect the IP-CS to be registered to the network and, if
necessary, the power supply.
Click Registration.
A dialogue box will appear. Non-registered (available) IP-CSs are
displayed on the left.
Highlight IP-CSs and click the right arrow to select them for
registration. Click Next.
If the registration is still in progress, the dialogue box will show
"Registration Executing".
If the registration is successful, the dialogue box will show
"Registration Completed". Click Close.
Once the IP-CS is successfully registered, the status of the IP-CS
will update to show "Registered".
Click De-registration.
A dialogue box will appear. Registered IP-CSs are displayed on the
left.
Highlight IP-CSs and click the right arrow to select them for de-
registration. Click Next.
A dialogue box will appear.
Click Confirm.
If the de-registration is successful, the dialogue box will show "De-
registration Succeed".
Click Close.
Once the IP-CS is successfully de-registered, the status of the
IP-CS will update to show "None".
Description
Value
Links
Range