Panasonic KX-NS300 Pc Programming Manual page 542

18.3.1 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID Table—Automatic Registration
Name
Tenant
Number
UM Service
Group No.
VM Trunk
Group No.
CLI Ring for
DDI/DID—
Day, Lunch,
Break, Night
18.3.1 PBX Configuration—[10-3] CO & Incoming Call—DDI / DID
Table—Automatic Registration
Automatic Registration allows DDI/DID numbers and DDI/DID destinations in each time mode (day/lunch/
break/night) to be programmed at once for a set of locations in series.
542 PC Programming Manual
Description
Specifies the tenant number,
to determine the Time Table
by which calls are distributed
depending on the time of day.
Specifies the Service Group
number sent to the Unified
Messaging system when the
incoming call destination is the
floating extension number of a
UM group.
The Service Group number is
used to allow the Unified
Messaging system to send the
applicable greeting message
to the caller.
Specifies the number of the
VM trunk group sent to the
VPS when the incoming call
destination is the floating
extension number of a VM
(DPT) Group. The VM trunk
group number is used to allow
the VPS to send the
applicable greeting message
to the caller.
Enables CLI distribution in
each time mode.
Value Range
1–8 PC Programming Manual
References
10.4 PBX Configuration—[2-4]
System—Week Table
Feature Manual References
2.1.1.3 Direct Inward Dialling (DID)/
Direct Dialling In (DDI)
None, 1–64 Feature Manual References
2.1.1.3 Direct Inward Dialling (DID)/
Direct Dialling In (DDI)
3.1.1 Unified Messaging System
Overview
1–48
Disable, PC Programming Manual
Enable
References
14.1 PBX Configuration—[6-1]
Feature—System Speed Dial
Feature Manual References
2.1.1.3 Direct Inward Dialling (DID)/
Direct Dialling In (DDI)
2.1.1.5 Calling Line Identification
(CLI) Distribution
Links