Installing And Connecting Cross-Connect Terminals; Introduction - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Installing and connecting
cross-connect terminals
Contents

Introduction

This section contains the following topics:
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Terminal block requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Terminal block requirements for the Cabinet system. . . . . . . . . . . .
Terminal block requirements for the Chassis system. . . . . . . . . . . .
Installing the BIX cross-connect terminal. . . . . . . . . . . . . . . . . . . . . . .
Installing the Reichle Masari cross-connect terminal (Germany). . . . .
Installing the Krone Test Jack Frame for the UK . . . . . . . . . . . . . . . . .
Connecting the cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter describes how to install and connect a cross-connect terminal to
a Small System, using either:
• a BIX cross-connect terminal
• a Reichle Masari cross-connect terminal, or
• a Krone Test Jack Frame (UK)
Note: Although the use of the BIX system is not mandatory, it is the
recommended choice.
Small System Installation and Configuration
Page 235 of 562
235
236
236
237
238
241
244
249