6.13 Automatic Program Start; Application - HEIDENHAIN TNC 620 User Manual

6

6.13 Automatic program start

Application

Refer to your machine manual.
The control must be specially prepared by the machine
tool builder for use of the automatic program start
function.
Caution: hazard to the user!
The AUTOSTART function automatically starts the machining
operation. Open machines with unsecured work envelopes pose a
huge danger for the machine operator.
Use the AUTOSTART function exclusively on enclosed
machines
In a Program Run operating mode, you can use the AUTOSTART
soft key to define a specific time at which the NC program that is
currently active in this operating mode is to be started:
Display window for setting the starting time
Time (h:min:sec): Time of day at which the
NC program is to be started
Date (TT.MM.JJJJ): Date at which the
NC program is to be started
To activate the start, press the OK
298
DANGER
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
Testing and running | Automatic program start