HEIDENHAIN TNC 620 User Manual page 333

Pallets | Batch Process Manager (option 154)
Icon Meaning
Incorrect program structure (e.g., pallet does not
contain any subprograms)
Workpiece preset is defined
Check input
You can assign a workpiece preset either to the
pallet or to all NC subprograms.
Operating notes:
In Programming operating mode, the T column is
always empty because the control first checks the
status in the Program run, single block and Program
run, full sequence operating modes.
If the tool usage test function is not enabled or is not
switched on for your machine, then no icon is shown
in the Pgm column
Further information: "Tool usage test", Page 145
In the Sts columns, the machining status is indicated by icons.
The icons have the following meanings:
Icon Meaning
Workpiece blank, machining required
Partially machined, requires further machining
Completely machined, no further machining
required
Skip machining
Operating notes:
The machining status is automatically adjusted during
machining
The Sts column is shown in Batch Process Manager
only if the pallet table contains the W STATUS column
Further information: "Tool-oriented machining",
Page 326
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
8
333