HEIDENHAIN TNC 620 User Manual page 497

Tables and overviews | Machine-specific user parameters
Parameter settings
DisplaySettings
Display mode for time of day
Selection of display mode
Analog
Digital
Logo
Analog and logo
Digital and logo
Analog on logo
Digital on logo
DisplaySettings
Link row on/off
Display settings for link row
OFF: Switch off the information line in the operating-mode line
ON: Switch on the information line in the operating-mode line
DisplaySettings
Settings for 3-D simulation graphics
Model type of the 3-D simulation graphics
3-D: Model depiction for complex machining operations with undercuts (compute-inten-
sive)
2.5-D: Model depiction for 3-axis operations
No Model: Model depiction is deactivated
Model quality of the 3-D simulation graphics
very high: High resolution; the block end points can be depicted
high: High resolution
medium: Medium resolution
low: Low resolution
Reset tool paths in new BLK form
ON: With new BLK form in Test Run, the tool paths are reset
OFF: With new BLK form in Test Run, the tool paths are not reset
Write graphics journal files after restart
OFF: Do not generate journal data
ON: Generate journal data after a restart for diagnostic purposes
DisplaySettings
Position display settings
Position display with TOOL CALL DL
As Tool Length: The programmed oversize DL is considered to be the change in tool
length for display of the workpiece-based position
As Workpiece Oversize: The programmed oversize DL is considered to be the workpiece
oversize for display of the workpiece-based position
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
12
497