HEIDENHAIN TNC 620 User Manual page 362

9
9.11 Configuring the HR 550FS radio handwheel
Application
This setup dialog is managed by the HEROS operating
system.
After you have changed the conversational language on
your control, you need to restart the control to enable the
new language.
To configure the HR 550FS wireless handwheel, use the
SET UP WIRELESS HANDWHEEL soft key. The following functions
are available:
Assigning the handwheel to a specific handwheel holder
Setting the transmission channel
Analyzing the frequency spectrum for determining the optimum
transmission channel
Selecting transmitter power
Statistical information on the transmission quality
Any changes or modifications that were not expressly
approved by the party responsible for conformity could
void your authority to operate the device.
This device complies with Part 15 of the FCC Rules and
the RSS standard(s) of Industry Canada for license-
exempt equipment.
Operation is subject to the following conditions:
1 The device must not cause any harmful interference.
2 The device must be tolerant to any interferences it
receives, including interference that might impair its
operation.
Assigning the handwheel to a specific handwheel holder
To assign a handwheel to a specific handwheel holder, the
handwheel holder must be connected to the control hardware.
To assign a handwheel to a specific handwheel holder, proceed as
follows:
Place the handwheel in the handwheel holder
Select the Machine settings group in the MOD menu
Press the SET UP WIRELESS HANDWHEEL soft key
The control opens a pop-up window.
Select the Connect HW button
The control saves the serial number of the inserted wireless
handwheel and displays it in the configuration window to the
left of the Connect HW button.
Select the END button
The control saves the configuration.
362
MOD functions | Configuring the HR 550FS radio handwheel
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022