HEIDENHAIN TNC 620 User Manual page 504

12
Parameter settings
Settings for the NC editor
Generate backup files
TRUE: Generate backup file after editing NC programs
FALSE: Do not generate backup file after editing NC programs
Behavior of the cursor after deletion of lines
TRUE: Cursor is placed on the preceding line after deletion (behavior of iTNC)
FALSE: Cursor is placed on the following line after deletion
Behavior of the cursor on the first or last line
TRUE: Cursor jumps from end to beginning of program
FALSE: Cursor is not allowed to jump from end to beginning of program
Line break on blocks with more than one line
ALL: Always display all lines
ACT: Only display the lines of the active block completely
NO: Only display all lines when block is edited
Activate help graphics when entering cycle data
TRUE: Always display help graphics during input
FALSE: Only display help graphics when the CYCLE HELP soft key is set to ON. The CYCLE HELP
OFF/ON soft key is displayed in Programming operating mode after pressing the "Screen layout"
key
Behavior of the soft-key row after entering a cycle
TRUE: The cycle soft-key row remains active after a cycle definition
FALSE: The cycle soft-key row is hidden after a cycle definition
Confirmation request when deleting a block
TRUE: Display confirmation request when deleting an NC block
FALSE: Do not display confirmation request when deleting an NC block
Line number up to which a test of the NC program is to be run: Program length for which the geometry is
to be checked
100 to 50000
ISO programming: Increments for creation of ISO blocks in the program
0 to 250
Specify programmable axes
TRUE: Use the specified axis configuration
FALSE: Use the default axis configuration XYZABCUVW
Behavior of paraxial positioning blocks
TRUE: Paraxial positioning blocks enabled
FALSE: Paraxial positioning blocks disabled
504
Tables and overviews | Machine-specific user parameters
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022