Machining And Program Run - HEIDENHAIN TNC 370 D Technical Information

Machine Function and input
parameter
MP7311 Drawing mode for editing graphics
Input: %xxxxxxxx
Bit 0 : 0/1 = do not indicate/indicate infeed
points
Bit 1 : 0/1 = do not draw/draw pocket
meanders
Bit 2 : 0/1 = do not draw/draw compensated
contours
Bit 3-7 Reserved
MP7330.0-15 Definition of parameters as user parameters
Input: 0 to 9999.99 (no. of the desired
machine parameters)
MP7340.0-15 Dialogs for user parameters
Input: 0 to 199 (line number in the PLC
dialog file)

4.14 Machining and Program Run

Machine Function and input
parameter
MP7410 Scaling factor cycle in two or three axes
Input:
0 = Scaling factor cycle effective in all three
primary axes
1 = Scaling factor cycle effective only in the
working plane
MP7411 Tool data in touch probe block
Input:
0 = With the touch probe block the current
tool data are overwritten with the
calibrated data of the probe system.
1 = The current tool data are retained even
with a touch probe block.
MP7415.0 Type of transition element with M112
Input: %000000xx
(recommended input value %00000011)
0 = insert circular arc
1 = insert cubic spline
2 = insert 5
3 = insert 7
Bits 2 to 7 Reserved
July 02
th
degree polynomial
th
degree polynomial
Machine Parameters
Change via Reaction
CN
PLC
RUN
PLC
RUN
Change via Reaction
CN
PLC
RUN
CN
PLC
RUN
TNC 370 D 4–75