HEIDENHAIN TNC 620 User Manual page 351

MOD functions | Changing the machine settings
9.9 Changing the machine settings
Selecting the kinematics
Refer to your machine manual.
The Kinematics function will be configured and enabled
by your machine tool builder.
Danger of collision!
All stored kinematics can also be selected as active machine
kinematics. By this means, all manual movements and machining
operations are executed using the selected kinematics. All
subsequent axis movements pose a risk of collision!
Use the Kinematics function exclusively in the Test Run
operating mode
Use the Kinematics function for selecting the active machine
kinematics only if required
The Kinematics MOD function in the Machine settings group allows
you to select different kinematics as machine kinematics for the
test run. You can use this function to test NC programs whose
kinematics does not match the active machine kinematics.
The various kinematics must be defined and enabled by the machine
tool builder. When you select a kinematics for the test run, the
machine kinematics remains unaffected.
To change the kinematics, proceed as follows:
Select the Machine settings group in the MOD menu
Select the Kinematics function
Select the desired kinematics for the SIM channel
Press the APPLY soft key
Press the OK soft key
The control saves the selected kinematics for the Test Run
operating mode.
Ensure that you have selected the correct kinematics
in the Test Run operating mode for checking your
workpiece.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
NOTICE
9
351