HEIDENHAIN TNC 620 User Manual page 336

8
Creating a job list
You can only create a new job list in the file manager.
The file name of a job list must always begin with a letter.
Press the Programming key
Press the PGM MGT key
The control opens the file manager.
Press the NEW FILE soft key
Enter the file name with extension (.p)
Confirm with the ENT key
The control opens an empty job list in Batch
Process Manager.
Press the INSERT REMOVE soft key
Press the INSERT AFTER soft key
The control displays the various types on the
right-hand side.
Select the desired type
The control inserts an empty line in the job list.
The control shows the selected type on the right-
hand side.
Define the entries
Confirm your entries by pressing the ENT key.
Repeat the steps if required
Press the EDIT soft key
336
Pallet
Clamping
Program
Name: Enter the name directly or select one by
means of the pop-up window, if there is one
Datum table: Enter the datum directly, where
applicable, or select one by means of the pop-
up window
Preset: Enter the workpiece preset directly,
where applicable
Locked: The selected line is excluded from
machining
Machinable: The selected line is enabled for
machining
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
Pallets | Batch Process Manager (option 154)