Pallets | Pallet management (option number 22)
Executing a pallet table
A machine parameter defines whether the control is to
execute the pallet table blockwise or continuously.
To execute a pallet table, proceed as follows:
Switch to Program run, full sequence or
Program run, single block operating mode
Press the PGM MGT key
If no pallet tables are shown:
Press the SELECT TYPE soft key
Press the SHOW ALL soft key
Select a pallet table with the arrow keys
Press the ENT key
Select the screen layout, if necessary
Execute with the NC Start key
Proceed as follows to check the NC program content before
execution:
Select pallet table
With the arrow keys, select the NC program you would like to
check
Press the OPEN THE PROGRAM soft key
The control displays the selected NC program on
the screen.
Scroll through the NC program with the arrow
keys
Press the END PGM PAL soft key
The control returns to the pallet table.
A machine parameter defines how the control is to react
after an error.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
8
323