HEIDENHAIN TNC 620 User Manual page 75

Fundamentals | Status displays
Tool measurement (TT tab)
The control displays this tab only if the function is active
on your machine.
Soft key Meaning
No direct Active tool
selection
possible
Minimum tilt angle (MIN) of the tool touch probe
Maximum tilt angle (MAX) of the tool touch probe
Tolerance for tilt angle (DYN)
Measurement results of the cycle:
Field Meaning
1 Tilt angle of positive X direction
2 Tilt angle of positive Y direction
3 Tilt angle of negative X direction
4 Tilt angle of negative Y direction
11 X position of tool touch probe in
machine coordinate system (M-CS)
12 Y position of tool touch probe in
machine coordinate system (M-CS)
13 Z position of tool touch probe in
machine coordinate system (M-CS)
14 Diameter or edge length of probe
contact
15 Angle of misalignment
Your machine tool builder defines the tolerance
for the tilt angle in the optional machine parameter
tippingTolerance (no. 114319). The control will
determine the tilt angle automatically only if a tolerance is
defined.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
3
75