Saving Presets In The Table - HEIDENHAIN TNC 620 User Manual

5

Saving presets in the table

Refer to your machine manual.
The machine tool builder can disable presetting in
individual axes.
The machine tool builder can define a different path for
the preset table.
The preset table has the name PRESET.PR, and is saved in the TNC:
\table\ directory by default.
PRESET.PR is editable in the Manual operation and
Electronic handwheel operating modes only after you have
pressed the CHANGE PRESET soft key. You can open the PRESET.PR
preset table in the Programming operating mode but not edit it.
There are several methods for saving presets and basic rotations in
the preset table:
Manual input
Using the touch probe cycles in the Manual operation and
Electronic handwheel operating modesElectronic handwheel
Using touch probe cycles 400 to 405, 14xx and 410 to 419 in
automatic mode
Further information: User's Manual for Programming of
Measuring Cycles for Workpieces and Tools
Operating notes:
In the 3-D ROT menu, you can specify that the basic
rotation is also effective in the Manual Operation
mode.
Further information: "Activating manual tilting",
Page 242
When presetting, the positions of the tilting axes must
match the tilted situation.
The behavior of the control during presetting depends
on the setting in the optional machine parameter
chkTiltingAxes (no. 204601).
Further information: "Introduction", Page 204
PLANE RESET does not reset the active 3-D ROT.
In row 0 the control always saves the preset that you
most recently set manually via the axis keys or via soft
key. If the preset set manually is active, the control
displays the text PR MAN(0) in the status display.
Copying the preset table
Copying the preset table into another directory (for data backup)
is permitted. Write-protected lines are also write-protected in the
copied tables.
Do not change the number of lines in the copied tables! If you want
to reactivate the table, this may lead to problems.
To activate the preset table copied to another directory you have to
copy it back.
If you select a new preset table, you need to reactivate the preset.
194
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
Setup | Preset management