HEIDENHAIN TNC 620 User Manual page 492

12
Changing the display of the parameters
If you are in the configuration editor for the user parameters, you can
change the display of the existing parameters. In the default setting,
the parameters are displayed with short, explanatory texts.
Proceed as follows in order to have the actual system names of the
parameters be shown:
Press the Screen layout key
Press the SHOW SYSTEM NAME soft key
Follow the same procedure to return to the standard display.
Displaying help texts
The HELP key enables you to call a help text for each parameter
object or attribute.
If the help text does not fit on one page (1/2 is then displayed at the
upper right, for example), press the HELP PAGE soft key to scroll to
the second page.
The control displays other information (e.g. unit of measurement,
initial value, selection list) in addition to the help text. If the selected
machine parameter matches a parameter in the previous control
model, the corresponding MP number is displayed.
List of user parameter
Refer to your machine manual.
The machine tool builder can make additional
machine-specific parameters available as user
parameters, so that you can configure the functions
that are available.
The machine tool builder can adapt the structure and
contents of the user parameters. The display on your
machine may be different.
492
Tables and overviews | Machine-specific user parameters
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022