HEIDENHAIN TNC 620 User Manual page 391
Setup, testing and running nc programs
Hide thumbs
Also See for TNC 620:
- User manual (616 pages) ,
- Operating instructions manual (64 pages) ,
- User manual (571 pages)
Table of Contents
Advertisement
HEROS functions | Window manager
Manual installation of a session certificate
A new certificate must be installed if no valid session certificate is
installed on the control. Contact the responsible service technician to
determine which certificate you need. He will then provide you with a
valid certificate file if necessary.
Proceed as follows to install the certificate on the control:
Open the task bar at the bottom edge of the screen
Press the green HEIDENHAIN button to open the HEROS menu
Select the Settings menu item
Select the Network menu item
The control opens the Network settings dialog.
Select the Internet tab. The settings in the Telemaintenance
field are configured by the machine manufacturer.
Press the Add button
Select the file in the selection menu
Press the Open button
The certificate is opened.
Press the OK soft key.
It may be necessary to restart the control to load the settings
Starting the service session
To start a service session, proceed as follows:
Open the task bar at the bottom edge of the screen
Press the green HEIDENHAIN button to open the HEROS menu
Select the Diagnostic menu item
Select the RemoteService menu item
Enter the Session key of the machine manufacturer
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
10
391
Advertisement
Table of Contents
